Necta KIKKO ES6, Installation, Use And Maintenance Manual

Page: 29 / 76

25
© by NECTA VENDING SOLUTIONS SpA 02-2004 184 02
MDB protocol Audit
Audit 1 Money in the tubes
Money present in the change tubes that moment
Audit 2 Money to the tubes
Money sent to the change tubes
Audit 3 Money to the box
Money sent to the coin box
Audit 4 Change return
Total money returned
Audit 5 Excess
Excess money. Extra amounts paid by the customer that
were not returned (in the event there was no money
available for return)
Audit 6 Releasing tubes
Value of coins dispensed with the “Tubes control” function
Audit 7 Filling tubes
Value of money cashed with the manual loading function
Audit 8 Cash sales
Value of total sales with cash money (coins + bills)
Audit 9 Cashed bills
Value of cashed bills
Audi. 10 Charge key
Value of money changed into the key
Audi. 11 Sales with key
Value of money cashed for dispensing with key
Audit. 12 Money dispensed manually
Value of coins dispensed manually with the dispensing
buttons on the coin mechanism.
DISPLAY THE SELECTION COUNTERS
This function is used to enable/disable the display of the
total number of drinks sold since the last statistic reset,
during the start-up phase of the machine.
PRINT
Connect an RS-232 serial printer with a Baud rate of 9600,
8 data bit, no parity, 1 stop bit to the serial port located on
the push button board, to print all the statistics described
in the section “Displaying the statistics”. The hardcopy
printout will also contain the machine code, the date and
the software version.
Statistics can be printed partially or totally.
To connect the printer, do as follows:
- press the confirm print button “ ”, displaying the mes-
sage “Confirm?”;
- connect the printer before confirming;
- press the confirm button “ ” to start printing.
TEST
DISPENSING
With this function it is possible to obtain, with the door open
and without inserting any money, for each selection dis-
pensing of:
- complete selection
- water only
- powder only
- without accessories (cup, sugar and stirrer)
- accessories only
SPECIAL FUNCTIONS
By accessing this function it is possible to:
- activate the brewer unit;
- grind and release a coffee dose (not active in this model);
- open a solenoid valve to allow the intake of air in the event
of emptying the boiler for maintenance;
- manually install boiler.
AUTOTEST
This function allows testing of the main machine compo-
nents.
Press button “ ” and the message “AUTOTEST” will start
blinking.
Press button “ ” to cancel the operation, confirm with
button “ ” to start the autotest routine.
In a sequence:
- activation of the doser units for 2 seconds
- activation of the mixers for 2 seconds
- releasing a cup
- releasing a stirrer
- switching on of the fluorescent lamps
- the door LEDs are lit
- push-button panel test; the machine will display the
number of the button which must be pressed and awaits
the actuation before going to the next button
- operation/repositioning of the dispensing spouts
- rotation of the brewer unit
- waste container switch; the machine awaits until the
waste container micro-switch is manually operated.