Necta KIKKO ES6, Installation, Use And Maintenance Manual

Page: 23 / 76

19
© by NECTA VENDING SOLUTIONS SpA 02-2004 184 02
PROGRAMMING PARAMETERS
CASH
This set of functions controls all parameters regarding the
payment systems and the sales prices.
SELECTION PRICES
Four different prices can be set for each selection accord-
ing to the programmed time bands for when the time table
option is enabled.
For each of the 4 time bands prices (0 to 65,535) can be
programmed globally (same price for all selections) or for
the single selections.
Should the majority of products be sold at the same price,
it will be convenient to set the price globally and then
change the figure of the selections with different prices.
TIME BANDS
Four programmable time bands are provided for selling
products at different prices.
The time periods are programmable for beginning and end
time by hours (00 to 23) and minutes (00 to 59).
If the values for start and end of the time band are set to
00.00 the time period is disabled.
The reference time is kept by an internal clock, program-
mable as:
day/month/year week-day 1-7
and then
hour/minutes/seconds.
COIN MECHANISMS
It is possible to decide which of the payment system
protocols available are to be enabled for the functions.
The available payment systems are:
- Executive
- Validators
- BDV
- MDB
By selecting one of the systems it is possible to control its
functions.
EXECUTIVE
The following payments systems are available for the
Executive system:
- Standard
- Price Holding
- Coges
- U-Key
- Sida
VALIDATORS
When the “Validat. Lines” (line setting) function of the
“technician” menu is displayed, the value of the 6 validator
coin lines, A to F, can be changed.
BDV
The BDV protocol menus are used for defining the follow-
ing functions:
Type of vending
Setting the operating mode for multiple or single dispens-
ing. With multiple dispensing, the change is not automati-
cally returned after a successful selection; however the
credit is available for further selections. When pressing the
coin return button, the available credit is returned if its value
is lower than the maximum change value.
Change control
This function enables/disables the return of credit if no
selections are made.
If enabled, this function allows the return of coins even if the
first selection was not dispensed.
If however a selection fails for any reason, the change will
be returned if requested.
Maximum credit
This function is used to define the maximum accepted
credit.
Maximum change
It is possible to set a limit to the total amount of change
returned by the coin mechanism when pressing the coin
return button or after a single dispensing serving.
Any credit exceeding the amount programmed with this
function will be cashed.
Accepted coins
It is possible to define which, among the coins recognised
by the validator, are to be accepted.
Check the label on the coin mechanism for the correct coin
to value matching, indicating the position of the coins.
Not accepted coins
This function programs the rejection of coins when in
“exact amount” mode.
Check the label on the coin mechanism for the correct coin
to value matching, indicating the position of the coins.
Dispensing buttons
This function enables or not the buttons on the coin
mechanism used to release the coins in the change return
tubes.
Value of “exact amount”
This value defines the combination of empty coin tubes,
setting the coin mechanism in “exact amount” mode. The
possible combinations of empty coin tubes are indicated
below.
For greater simplicity, the combination is described with
reference to tubes A, B and C, where tube A receives the
lower value coins and tube C the greater value coins.