Necta KIKKO ES6, Installation, Use And Maintenance Manual

Page: 14 / 76

© by NECTA VENDING SOLUTIONS SpA
10
02-2004 184 02
Fig. 12
Installation and the following maintenance operations
should be carried out with the machine switched on and
therefore by qualified personnel only, who are trained in the
correct use of the machine and informed about the specific
risks of such situation.
To energize the system with the open door, simply insert
the special key into the slot (see Fig. 11).
The door can be closed only after removing the yellow key
from door switch and lowering the machine top panel.
The machine must be installed in a dry room with
temperature between 2°C and 32°C.
At installation the hydraulic circuits and the parts in
contact with foodstuff should be fully sanitised to
remove any bacteria which might have formed during
storage.
UNPACKING THE VENDING MACHINE
After removing the packing, ensure that the machine is
intact.
If in doubt do not use the machine.
No packing elements (i.e. plastic bags, polystyrene
foam, nails, etc.) should be left within the reach of
children, as they are potentially dangerous.
Packing materials must be disposed of in authorised
containers and the recyclable ones must be recovered by
qualified companies.
Important notice!!
The machine should be positioned with a maximum incli-
nation of 2°.
If necessary provide proper levelling by way of the adjust-
able feet included (see Fig. 12).
INSERTING THE PRODUCT LABELS
The labels indicating the available product selections are
supplied with the machine and must be inserted into the
special slots at installation, fitting the cover.
According to the model, some buttons may not be used
(refer to the selection dose table).
CONNECTING THE MACHINE
TO THE WATER MAINS
The machine must be connected to the drinking water
mains, taking into account law provisions in force in the
country where the machine is installed.
The water pressure must be 0.05 to 0.85 Mpa (0.5 - 8.5
bar).
Run some water from the mains until it is clear and without
impurities.
Use a hose capable of withstanding the water mains
pressure and suitable for use with foodstuff (min. inside
diameter of 6 mm) to connect the water supply to the fitting
(3/4" gas) of the water inlet solenoid valve (see Fig. 13).
Chapter 2
INSTALLATION
Fig. 11
1 - Door switch
2 - Permanently live socket (230 V~ 2 A. Max)
3 - Mains fuses
4 - RS232 serial port
5 - Programming access button
6 - Mixer wash button
1 - Adjustable foot