Necta KIKKO ES6, Installation, Use And Maintenance Manual

Page: 16 / 76

© by NECTA VENDING SOLUTIONS SpA
12
02-2004 184 02
INSTALLING THE PAYMENT SYSTEM
The machine is sold without payment system, there-
fore the installer of such a system has sole responsi-
bility for any damage to the machine or to things and
persons caused by incorrect installation.
Install the coin mechanism paying attention, according to
the type used, to:
- securing the coin mechanism onto the support, choosing
the most suitable securing holes;
- loosening the fastening screw and adjusting the coin slot
chute according to the coin mechanism opening;
- loosening the fastening screws and adjusting the selector
opening lever.
Fig. 16
- bleed air out of the softener unit by loosening the plug, wait
until it is full of water and tighten the plug, let a few litres
of water flow out until it is clear;
- re-insert the hose connected to the air-break.
Fig. 15
CLEANING THE SOFTENER RESINS
(
MODELS
C
ONLY
)
Before filling the machine water system the resins con-
tained in the softener unit must be cleaned, operating as
follows:
- remove the hose connected to the air-break from the
softener unit fitting (see Fig. 16);
- insert a new hose, provided with the machine, onto the
now free hose fitting and direct it towards a drain;
- switch the machine on;
FILLING THE WATER SYSTEM
If the air-break device indicates the no-water condition for
more than 10 seconds after the machine has been switched
on, an installation cycle will automatically be started, and
namely:
- the display will show
“INSTALLATION”
for the entire duration of the cycle;
- the air-break and the instant product boiler are filled;
- (for espresso models only) the coffee solenoid valve is
opened so that air may be bled from the boiler and 800 cc.
of water filled.
N.B.: If there is no water flow from the mains during the
installation cycle, the machine will be blocked until the
water is resumed or the machine is switched off.
This operation must be carried out manually, using the
special function from the “test” menu in “Technician”
mode, if the kit (optional) for water supply from an
internal tank is fitted or after any maintenance requiring
the boiler to be emptied but not the air-break.
INSTALLATION IN A BANK OF MACHINES
The machine control system is pre-arranged for the con-
nection in a bank of vending machines using special kits.
This permits the use of a single payment system and
remote connection (GSM) for more machines.
In the event of installation in a bank of machines, it can be
configured a “Master”, i.e. having control over the second
machine, or as “Slave”, i.e. leaving the control to the other
machine.
1 - Coin mechanism support
2 - Coin mechanism support adjustment
3 - Coin mechanism securing bracket
4 - Coin chute adjustment
5 - Coin chute vertical adjustment
6 - Coin return button adjustment
1 - From the water inlet solenoid valve
2 - To the air-break
3 - Cap
4 - Softener unit