Necta Brio Espresso, Installation, Use And Maintenance Manual

Page: 9 / 40

5
© by NECTA VENDING SOLUTIONS SpA 0101Brio C-I
The manufacturer declines all responsibility for any dam-
age caused by the use of strong or toxic chemicals.
Before starting any maintenance operations requiring
parts of the unit to be removed, the machine must
always be disconnected from the power supply.
CONTROLS AND INFORMATION
All user controls and information are located on the exter-
nal side of the door (see Fig. 2).
The labels with the selection menu and the instructions
supplied with the machine must be inserted at the time of
installation, referring to the selection dose table.
MAINTENANCE AND DISINFECTION
According to current safety rules and health regulations,
the operator of an automatic vending machine is respon-
sible for the hygiene and the maintenance of the foodstuff
circuits, to prevent formation of bacteria.
At installation the hydraulic circuits and the parts in
contact with foodstuff should be fully sanitised to
remove any bacteria which might have formed during
storage.
It is advisable that specific sanitising agents (such as
chlorine-based detergents or similar) are used for cleaning
also the surfaces which are not directly in contact with
foodstuff.
Some parts of the machine can be damaged by strong
detergents.
LOADING AND CLEANING
DOOR SWITCH
When opening the door a special switch disconnects the
power from the machine electrical system to allow the
operations described below, regarding loading and routine
cleaning, in full safety.
All operations requiring the machine to be energized
should be carried out by qualified personnel ONLY,
informed about the specific risks of such situation.
To energize the system with the door open, simply insert
the special key into the slot (see Fig. 1).
The door can be closed only after removing the key.
1 - Dispensing compartment
2 - Spaces for product labels
3 - Stirrer dispenser (manual version)
4 - Sugar packet taking (manual version)
5 - Coin slot (Mod. Executive)
6 - Coin return button (Mod. Executive)
7 - "Exact amount" warning light
8 - Alphanumeric display
9 - Available selection menu
10 - Labels for user's information
11 - Prearrangement for front validator and/or labels
12 - Coin return compartment
13 - "Jug facilities" key
Fig. 1
1 - Door switch
2 - Mechanical counter
3 - Net fuses
The Programming button, used to access the machine
functions, is located on the internal side of the push-button
board.
Press the Programming button twice to access "Program-
ming" mode.
Press selection button No. 5 to automatically start filling
the machine water system.
Fig. 2