Necta Brio Espresso, Installation, Use And Maintenance Manual

Page: 22 / 40

© by NECTA VENDING SOLUTIONS SpA
18
0101 Brio C-I
SETTING THE MACHINE CODE INSTALLATION
Pressing the installation button “5” will enable the filling
operation of the hydraulic system, even with the air break
full.
RESETTING FAILURES
When pressing the failure reset button “4” the message
"Working" is displayed for a few seconds and all current
failures will be reset.
DISPLAYING THE STATISTICS
Press the statistics display button "8" to display in a
sequence and at 1 second intervals, if no other buttons are
pressed, the stored data:
1 - single selection counter;
2 - single price counter;
3 - counter per type of coin cashed;
4 - total cash counter;
5 - failure counter.
PRINTING THE STATISTICS
The statistics described in the section "displaying the
statistics" can be printed with a RS-232 serial printer with
a Baud rate of 9600, 8 data bit, no parity, 1 stop bit,
connected to the serial port located on the push button
board (the CITIZEN I-DP 3110-24RF 230 A p/n 9210219
printer is recommended). The hardcopy printout will also
contain the machine code number and the printout pro-
gressive number.
The progressive hardcopy printout number can be reset
only by initializing the machine.
To connect the printer do as follows:
- Press the statistics print button “7” to display the message
"Confirm?";
- before confirming connect the printer;
- press the confirm button " " to start printing.
RESETTING THE STATISTICS
Press the statistics reset button “6” to display the message
"Confirm?" blinking.
Press the confirm button " ", the message "Working" is
displayed for a few seconds and the statistics are reset.
When the "Machine code" function is displayed
the identification code number of the machine
can be changed (from the default 0000 to a
number up to 9999).
Press the confirm button " " to display the
current code; when pressing the change button
“ ” the first digit will blink.
The buttons will have numeric values.
When pressing a button, the blinking digit will be
given the displayed value and the next digit
starts blinking.
MACHINE CONFIGURATION
When the "Machine Config." function is dis-
played, the machine configuration can be
changed, and namely:
- water supply from the mains / internal tank
- for instant models, before releasing the cup,
dispensing 20 cc. of water to heat the coffee
mixer; this function can either be enabled or
disabled
Press the confirm button " " to display the current status;
when pressing the change button “ ” the status blinks and
can be changed with the “ ” and “ ” buttons.
IMPORTANT NOTICE!!!
When the machine is initialised, the configuration will
be assigned the default values: "Water supply from
the mains/mixer heating enabled".
AFTER INITIALISING THE MACHINE MUST BE
RECONFIGURED.
SELECTION COUNTER
This function is used to lock the machine after a preset
number of coffee selections, and a preset number of
instant selections.
Since this is a control tool used only by the vending
manager, a 4-digit password must be entered.
After entering the password, the number of selections,
after which the machine locks, can be set, the number of
selections already made can be read and the lock counter
can be reset.
N.B.: The counters are set to zero by default;
With the counters set to zero, this function is disabled.