Necta Brio Espresso, Installation, Use And Maintenance Manual

Page: 23 / 40

19
© by NECTA VENDING SOLUTIONS SpA 0101 Brio C-I
PROGRAMMER
(O
PTIONAL
)
AUTOMATIC SETUP TRANSFER
Using the programmer device makes it possible to read out
the programming routines set and transferred to other
apparatuses from a given vending machine.
These data are preserved also when the programmer is
disconnected thanks to a couple of Duracell batteries
LR03 Format AAA 1.5 V (to be replaced every 12 months).
The programmer allows up to twenty different programs
(setups) to be stored.
To identify, among the 20 setups available, those contain-
ing data, a special character is displayed, and more
precisely:
< - > = Setup free
< > = Setup with data.
When creating the setup only the programs containing
data are available; if no setup contains data, the message
"no data available" will appear on the programmer display.
The special holder (see Fig. 17) is used to connect the
programmer to the machine, connecting the cable to the
special connector of the push-button board (see Fig. 21).
Then enter the "programming" mode and press twice the
relevant button on the push-button board (see Fig. 21).
Now, by inserting the programmer in its holder, an auto-
matic connection will take place, and the setup menu will
be shown on the programmer display:
- Pressing button “E” will access the displayed
function;
- Pressing button “O” will display the following
function;
- Pressing button “C” will display the previous
function.
1 - Connector
2 - Programmer holder
3 - Programmer
Fig. 17
PROGRAMMER SETUP READING SETUP 01 <X>
SETUP READING SETUP 01 <X> Confirm?
SETUP READING
SETUP 20 <X>
PROGRAMMER CREATE SETUP SETUP 01 <X>
CREATE SETUP SETUP 01 <X> Confirm?
CREATE SETUP
SETUP 20 <X>
TRANSFERRED DATA
Data transferred with the set up is as follows:
· Water doses
· Powder doses
· 8 price table
· Prices/selection status
· Basic unit
· Decimal point position
· Validator lines value
· Machine lock counter
SETTING THE LANGUAGE
It is possible to change the programmer configuration as
concerns the language in which the messages are to be
displayed as well as to reset all of the data therein contained.
To activate the "Programmer configuration" operate as
follows:
- insert the programmer into the holder and start the
machine.
- wait approx. 10" and then press the programmer buttons
"C" and "O"; the first function will be thus displayed:
LANGUAGE CONFIGURATION CONFIGURATION
CONFIGURATION ITALIAN Confirm?
CONFIGURATION
FRENCH
CONFIGURATION
GERMAN
CONFIGURATION
ENGLISH
CONFIGURATION
SPANISH
CONFIGURATION INITIALISE
INITIALISE
Confirm?
CONFIGURATION
CONFIG. END
Exit from the configuration menu
The software starts again from address 0000
(as when the machine is started)