Necta Brio Espresso, Installation, Use And Maintenance Manual

Page: 11 / 40

7
© by NECTA VENDING SOLUTIONS SpA 0101Brio C-I
The parts to be cleaned are:
- powder deposit drawers, mixer and instant drink dispens-
ing conduit;
- tea dispensing spout;
- sugar chute;
- dispensing compartment.
- remove the powder and the water funnels, the feeders,
the powder deposit drawers and the mixer wheels from
the mixers (see Fig. 6);
- in order to remove the wheels, with a finger block the disk
fitted on the mixer shaft;
- wash all parts with detergent being sure that all visible
residue and product layers are mechanically removed,
using a brush if necessary.
Disinfection should be carried out using chlorine-based
detergents.
- soak all components for approx. 20 minutes in a container
filled with the previously prepared chlorine-based deter-
gent;
- reinstall the feeders and the water funnels;
- reinstall the powder deposit drawers and the powder
funnels after thoroughly drying them.
After reinstalling all parts the following is however
required:
- access "Maintenance" mode to clean the mixer (see
relevant paragraph) and add a few drops of the chlorine-
based detergent in the various funnels.
- After disinfection thoroughly rinse all components to
ensure that all residue of the solution is removed.
CLEANING THE WATER SUPPLY TANK
(O
PTIONAL
)
For machines equipped with a water tank inside the
support cabinet, at least once a week, such tank must be
sanitised with the chlorine-based detergent used for the
mixers.
CLEANING THE LIQUID WASTE TRAY
The liquid waste tray can be removed easily for emptying
and cleaning.
If the special pins fitted on the container cover are removed
and inserted into the special holes (see Fig. 7), the tray can
be removed only with door open.
For safety reasons, when removing the tray a special
switch installed on the left-hand side will cut off the power
supply from the machine.
1 - Drawer cover
2 - Powder deposit drawer
3 - Powder funnel
4 - Water funnel
5 - Feeder
6 - Mixer wheel
Fig. 7
1 - Tray locking holes
2 - Pins
CLEANING THE CUP SHIFTING ARM
The cup shifting arm must be periodically removed and
cleaned. To be able to remove it, completely undo the
knurled nut (see Fig. 8). When reinstalling be sure the
spacer washer is correctly fitted.
1 - Knurled nut
2 - Cup shifting arm
3 - Spacer washer
Fig. 8
Fig. 6