NEC UX5000, Hardware Manual

Page: 214 / 334

4 - 20 Chapter 4
Chapter 4 - Terminals and Optional Equipment
4.5.2
Installing a 60-Button DSS Console to a Digital Keyset
1. Install a modular jack for each 60-Button DSS Console. The modular jack should be within six feet of the
terminal.
2. For each 60-Button DSS Console, run one-pair 24 AWG station cable from the cross-connect block to a
modular jack. Ground the unused pair.
3. Terminate the extension leads to GRN/RED of the modular jack. Terminate the unused leads to the jack.
4. The console can be physically attached to the keyset. First,
remove the right side panel from the keyset (or 16-Button
DLS, if installed). Hook a finger on the hollow indent on the
back of the terminal (near the top) and gently pull off the
panel.
5. Place the DSS side panel onto the side of the keyset and
screw into place using the 3 screws provided.
6. Slide the DSS Console over the DSS side panel until it
clicks into place.
7. Secure the console to the side panel using the 2 screws
provided.
8. Connect a line cord from the modular jack to the RJ11
connector on the bottom of the DSS console.
9. Route the line cord cable through the cable guide on the bottom of the console.
Side Panel
Dent
DSS Side Panel
Screws
DSS Console
Screws
Side Panel
Terminal
DSS Console
Line Cord Connector
Cable Channel