NEC Univerge SV9100, Manual

Page: 662 / 766

Issue 2.0
SV9100 Networking Manual 13-67
11 Networking System Number
(Network Mode only)
0 - 50 0
12
--- Not Used ---
13 Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up. Note that
there are different values based on the
setting in 10-03-12 for the PRI.
0 =Level 0 (lowest sensitivity)
1 =Level 1
2 =Level 2
3 =Level 3
4 =Level 4
5 =Level 5
6 =Level 6
7 =Level 7 (highest sensitivity) 2
14
Service Protocol for S-point
0 =Keypad facility
1 =Specified Protocol for Aspire
system
0
15
Call Busy Mode for S-point
0 =Alerting
1 =Disconnect 0
16 Two B-Channel Transfer for PRI
Service
0 =off
1 =on 0
17 ISDN Ringback Tone
If Telco does not provide ringback tone,
SV9100 can if 10-03-17 is set to
1:Enable.
0 =Disable
1 =Enable 0
18 Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
0 =Unknown
1 =International number
2 =National number
3 =Network Specific number
4 =Subscriber number
5 =Abbreviated number 0
19 Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for the
ISDN circuit.
0 =Unknown
1 =ISDN numbering plan
2 =Data numbering plan
3 =Telex numbering plan
4 =National standard numbering
plan
5 =Private numbering plan
0
20
Network Exchange Selection
Select the ISDN protocol for the ISDN
circuit.
0 =Standard (same as NI-2)
1 =reserved
2 =reserved
3 =DMS (A211)
4 =5ESS
5 =DMS (A233)
6 =4ESS
7 =NI-2 0
Item
No.
Item Input Data Default