NEC Univerge SV9100, Manual

Page: 361 / 766

Issue 2.0
SV9100 Networking Manual 6-15
22-02-01 Incoming Call Trunk Setup
Assign the incoming trunk type for each trunk.
Trunks 1 ~ 400
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching 0

44-02-01 Dial Analysis Table for ARS/F-Route Access
– Dial
Set the Dial digits for the Pre-Transaction Table
for selecting ARS/F-Route (eight digits max:
1 ~ 9, 0

# , @). To enter a wild card/don’t care
digit, press Line Key 1 to enter an @.
Maximum of eight digits.
(Use line key 1 for a ‘Don’t Care’
digit, @) No Setting

44-02-02 Dial Analysis Table for ARS/F-Route Access
– Service Type
Set the Service Type (0 ~ 3) for the Pre-
Transaction Table for selecting ARS/F-Route.
0 = No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option) 0

44-02-03 Dial Analysis Table for ARS/F-Route Access
– Additional Data
If a Service Type is selected in Program
44-02-02, set the additional data, if required, for
the Pre-Transaction Table for selecting ARS/F-
Route (24 digits max: 1 ~ 9, 0

# , @). To enter
a wild card/don’t care digit, press Line Key 1 to
enter an @.
1 = Delete Digit = 0 ~ 255
(255: Delete All Digits)
2 = 0 ~ 500
(0 = No Setting)
3 = Dial Extension Analyze
Table Number = 0 ~ 4
(0 = No Setting) 0

44-05-01 ARS/F-Route Table – Trunk Group Number
Assign the trunk group to be used by the ARS/
F-Route Table.
0-100,101-150,255
0 = Not Set
1~100 = Trunk Group from
PRG14-05
101~150 = Networking
255 = Extension Call
Default is 0 0

44-05-09 ARS/F-Route Table – Maximum Digit
Input the maximum number of digits to send
when using the F-Route.
0 ~ 24 0

84-10-01 ToS Setup – ToS Mode
When Input Data is set to 1, Protocol 7 is
invalid. When Data is set to 2, Protocols 2 ~ 6
are invalid.
0 = Disable (Invalid)
1 = IP Precedence
2 = Diffserv 0

Program
Number
Program Name/Description Input Data Default
Level
1 2 3