NEC Univerge SV9100, Manual

Page: 275 / 766

Issue 2.0
SV9100 Networking Manual 4-11
For BRIA PKG Setup
ISDN Line Number 01~04
Item
No
Item Input Data Default
01 ISDN Line Mode 0 = Not Used
1 = T-Point:1~400
2 = S-Point:1~960
3 = NW Mode (Leased Line): 1~256
4 = NW Mode (Interconnected Line):
1~256
5 = NW Mode (Interconnected Line,
Fixed Layer1=NT): 1~256
6 = S-Point (Leased Line): 1~960
1
02 Logical Port Number
 The starting port number of a BRI
line is displayed. Two logic ports are
automatically assigned to a BRI line.
0 = Not Used
1 = For T-Bus (1~400) 0
03 Connection Type 0 = Point-to-multipoint
1 = Point-to-Point 0
04 Layer 3 Timer Type
 Each timer value of Layer 3 is set up
for every type using Program 81-06
(T-Bus)
1~5 1
05 CLIP Information Announcement
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable 1
06 S-Point Connection Bus Mode 0 = Extended Passive Bus
1 = Short Passive Bus 0
07 S-Point DID Digit Range 0 ~ 4 0
08 Dial Sending Mode
ISDN Protocol definition
0 = Enblock Sending
1 = Overlap Sending 1
09 Dial Information Element
ISDN Protocol definition
[Only when Dialing Sending Mode
(10-03-08) is set for 1 (Overlap Sending]
0 = Keypad Facility
1 = Called Party Number 1
10 Master/Slave System
If set to 0, system is synchronized to
network clock. If set to 1, system is not
synchronized to the network clock.
0 = Slave System
1 = Master System 0
11 NW Mode Networking System Range 0 ~ 50 0