NEC TM1200, User Manual

Page: 112 / 134

5-12 Problem Solving
n
Is the power and signal cable to the CD-ROM drive properly installed?
n
Are all relevant switches and jumpers on the drive set correctly?
n
Is the drive properly configured?
n
Is the onboard IDE controller enabled?
Problems with Application Software
If you have problems with application software, perform the following:
n
Verify that the software is properly configured for the system. Refer to the software
installation and operation documentation for instructions on setting up and using the
software.
n
Verify a different copy of the software to see if the problem is with the copy that you
are using.
n
Make sure all cables are installed correctly.
n
Verify that the system board jumpers are set correctly. Refer to the “Configuring
Your System” chapter for jumper settings.
n
If other software runs correctly on the system, contact your vendor about the failing
software.
If the problem persists, contact the software vendor's customer service representative
for assistance.
Bootable CD-ROM Is Not Detected
Check the following:
n
Is the BIOS set to allow the CD-ROM to be the first bootable device? Check your
BIOS Setup (F2) configuration.