NEC POWERMATE PRO150, Manual

Page: 115 / 167

PowerMate Pro150 System
6
-15
PCI Configuration Status and Error Messages
The following PCI messages are displayed as a group with bus, device and
function information.
Message Explanation
Bad PnP Serial ID Checksum The Serial ID checksum of a Plug and Play
card was invalid.
Floppy Disk Controller Resource Conflict The floppy disk controller has requested a
resource that is already in use.
NVRAM Checksum Error, NVRAM
Cleared The ESCD data was reinitialized because
of an NVRAM checksum error. Try
rerunning the ICU.
NVRAM Cleared By Jumper The “Clear CMOS” jumper has been moved
to the “Clear” position and CMOS RAM has
been cleared.
NVRAM Data Invalid, NVRAM Cleared Invalid entry in the ESCD.
Parallel Port Resource Conflict The parallel port has requested a resource
that is already in use.
PCI Error Log is Full This message is displayed when more than
15 PCI conflict errors are detected. No
additional PCI errors can be logged.
PCI I/O Port Conflict Two devices requested the same resource,
resulting in a conflict.
PCI IRQ Conflict Two devices requested the same resource,
resulting in a conflict.
PCI Memory Conflict Two devices requested the same resource,
resulting in a conflict.
Primary Boot Device Not Found The designated primary boot device (hard
disk drive, diskette drive, or CD-ROM drive)
could not be found.
Primary IDE Controller Resource Conflict The primary IDE controller has requested a
resource that is already in use.
Continued