Options 3-13
OverDrive Processor Troubleshooting
If a fault occurs at power-on, verify that the installation was performed correctly. One
beep indicates that the computer has completed its power-on self-test. If intermittent beep-
ing occurs, turn off the computer and try again. If the beeping persists, see Section 4,
Maintenance and Troubleshooting.
Table Section 3-2 summarizes problems that may develop after installing a OverDrive proc-
essor and lists in sequential order suggested corrective actions.
Table Section 3-2 OverDrive Problems and Solutions
Problem
Symptom
Solution
No power
Power lamp on computer
status panel will not light.
1
. Check that the power cord is plugged into the
AC connector on the computer. Check that the
other end of the cord is plugged into a live
properly grounded AC power outlet.
Operating
system does
not boot
An invalid configuration
message is displayed.
1
. Press
F1
to run setup and view parameters.
OverDrive
Processor
malfunction
Software does not see
OverDrive Processor.
1
. Reseat the OverDrive Processor.
2
. Check the setup parameters
3
. Check the jumper settings (see Section 2).
4
. Replace OverDrive Processor.
5
. Replace system board.
Keyboard or
mouse
malfunction
Monitor has prompt, but
cannot input data.
1
. Check that the keyboard is plugged in.
2
. Check that the mouse is plugged in.
SIMM Memory Installation
The system board comes standard with 8 MB of memory. Memory over the first megabyte
of RAM is extended RAM. The desktop system supports up to 80 MB of memory while the
minitower supports up to 136 MB.
NOTE:
The metal plating on the SIMM stick
connectors must match the metal plating in the
SIMM sockets of the computer. Use tin-plated
SIMM sticks with tin-plated SIMM sockets.
Summary of Contents for POWERMATE P60D - SERVICE
Page 129: ......
Page 148: ...Minitower Repair 6 17 ...