2-12 Setup and Operation
Table Section 2-2 Advanced CMOS Setup Parameters
Parameter
Options
Description
Typematic Rate
Programming
Enabled or
disabled
Selects either enabled or disabled. When enabled, the
following two typematic options are available. Default
is disabled.
Typematic Rate
Delay (msec)
250, 500,
750 or
1000 msec
delay
Determines how long it takes for the auto-repeat function
to start when holding down a key on the keyboard.
Default is 500 msec.
Typematic Rate
(Chars/Sec)
6, 8, 10,
12, 15, 20,
24 or 30
Determines the speed at which characters repeat when
holding down a key on the keyboard. The higher the
number, the faster the rate. Default is 15.
Press <F1>
Message
Display
Enabled or
disabled
When enabled, the message “Press F1 key if you want
to run Setup” appears on the screen during power up.
Default is enabled and no message appears.
System Boot Up
Num Lock
On or off
Selects either on or off state of
NumLock
key on
keyboard. Default is off.
System Boot Up
Sequence
A:, C:
C:, A:
C: Only
Selects which drive the system checks first for boot up.
The default is A:, C:, enabling the system to first select
drive A for boot up, then drive C:. Select C:, A: to check
drive C first.
System Boot Up
CPU Speed
High or low
Selecting high (default setting) allows boot up to occur at
full speed. Selecting low results in slower boot up
operation.
Cache Memory
Enabled or
disabled
Selecting enabled (default setting) enables cache
memory. Selecting disabled disables cache memory.
Network
Password
Checking
Enabled or
disabled
Selecting enabled produces a password prompt when
attempting to connect to the network. Selecting disabled
(default setting) disables the password prompt.
ISA Linear
Frame Buffer
Disabled
1 MB
2 MB
4 MB
Use the 1 MB, 2 MB or 3 MB option if an ISA video
board is installed with a linear frame buffer or if
accessing memory located on the ISA bus immediately
below 16 MB. Memory allocated by these options is
taken from system memory. Default is disabled.
Set Linear
Frame Address
to:
(N/A)
15 MB
14 MB
12 MB
This parameter is automatically set by the “ISA Linear
Frame Buffer” option parameter. If the “ISA Linear Frame
Buffer” is set to disabled, the “Set Linear Frame Address
to” parameter is automatically set to N/A (not applicable).
Disable Shadow
Memory Size
Disabled
16 KB
32 KB
48 KB
64 KB
This selection disables shadowing up to 64 MB if the
shadow memory base is set to C0000h or D0000h. The
next parameter determines the base address of the non-
shadowed memory. Default is disabled.
Summary of Contents for POWERMATE P60D - SERVICE
Page 129: ......
Page 148: ...Minitower Repair 6 17 ...