Options 3-17
SIMM Installation
Install SIMM sticks into the system board as follows. Locate the SIMM sockets using
Figure Section 3-20.
1.
Remove the top cover and any expansion boards covering the socket as previ-
ously described.
2.
Remove the four 3 1/2-inch drive bracket screws (see Figure Section 3-24).
3.
Without removing the power and signal cables, place the 3 1/2-inch bracket with
the diskette drive and hard disk drive attached on the power supply.
Figure Section 3-24 3 1/2-Inch Drive Bracket Screws
4.
Insert the SIMM into the SIMM socket at an angle, then push the SIMM upright
so that the clips hold the SIMM in place (see Figure Section 3-26).
Figure Section 3-26 SIMM Installation
3 1/2-Inch
Drive Bracket
Four Screws
Power Supply
1 of 2
Clips
Summary of Contents for POWERMATE P60D - SERVICE
Page 129: ......
Page 148: ...Minitower Repair 6 17 ...