Power
Cabling for 200V to 240V Systems
4-2
Figure 4-1 Power Cable Routing for 100V to 120V Systems
3. Connect the remaining system component (such as the KVM switch) power cables
to the components.
4. Route the power cables to the appropriate power source. After all power cables are
routed, secure the cables to the cabinet frame with cable ties.
Do not connect the component power cables to the premises wiring at this time.
Component power cables are to be connected to the premises wiring during
5.3 Apply
AC Power Initially
.
4.2. Power Cabling for 200V to 240V Systems
Use the following procedure to connect components to the power strips. Before you
begin, review the power strip cabling topic for your system for guidance on cable
placement. The illustrated layout is a recommended layout. Your layout might look
different depending on your configuration requirements. If you are using 30-amp power
strips, your accessory strip might be eight receptacles instead of four.
Summary of Contents for NECCare Platinum Express5800/A1160
