1. Installing Internal Optional Devices
Express5800/R120d-2E User’s Guide
68
Chapter 2 Preparations
1.10.5
Installation
Install a DIMM by using the following procedure.
1.
Refer to steps 1 to 6 in
Chapter 2 (1.3 Overview of Installation and Removal)
for preparations.
2.
Lift the processor duct off the server.
3.
Open levers on left and right sides of
DIMM slot, and push the DIMM straight
into the socket.
When a DIMM is inserted into the socket,
the lever automatically closes.
Important
•
Make sure the orientation of the DIMM. The terminal side of a DIMM has a
notch, preventing being wrongly inserted.
•
Do not apply too much pressure when you push a DIMM into the socket.
Doing so can damage the socket or terminal part.
4.
Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
5.
Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, refer to
Chapter 3 (1. POST Error Message)
in "
Maintenance
Guide
".
6.
Run the SETUP utility, and select
Memory Configuration
and then
Memory Information
from the
Advanced
menu. Make sure the capacity of added DIMM is displayed properly.
Refer to
Chapter 2 (1. System BIOS)
in "
Maintenance Guide
".
7. Select
Memory Configuration
from the
Advanced
menu, and then specify
Yes
for
Memory Retest
.
After that, select
Save Changes and Exit
to reboot.
8.
Set the paging file size to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to
Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information))
in "
Installation Guide (Windows)
".
For other OS, consult the manual provided with the operation system or contact the store where you
purchased it or your maintenance service company.
Key slot
Key
