4-3.Connect Fibre Channel Devices
After install this product in the computer, following the steps described on the next step to connect
Fibre Channel devices.
1.
Check the power to the computer is off (System POWER LED off).
If the power to the computer is on (power lamp on), shut down the operating
system and then turn off the computer.
2.
Remove the dust cover from SFP+ module of the product
Make sure to keep the dust cover carefully.
3.
Check that the edge of the Fibre Channel cable and the holes of the connector of this product
are clear.
4.
Mate the cable connector and the connector of this product firmly in the correct direction.
Push the latch of the Fibre Channel cable to avoid conflict with the computer
flame and then insert the Fibre Channel cable until you hear it click.
If it is difficult to push the latch of the Fibre Channel cable with connect or
remove the Fibre Channel cable, use a flathead screw driver to push the
latch.
5.
Mate the other end of the cable connector and the Fibre Channel device firmly in the correct
direction.
Do not connect this product to a computer or Fibre Channel device that is not
recommended by NEC Corporation. If the product is connected to a computer
or Fibre Channel device that is not recommended by NEC Corporation, the
product may malfunction or fail.
Do not use Fibre Channel cable that is not recommended by NEC Corporation.
If the product is connected to Fibre Channel device by Fibre Channel cable
that is not recommended by NEC Corporation, the product may malfunction or
fail.
Use Fibre Channel cables under conditions that conform to the cable
specification (length between device, Fibre Channel data rate and so on).
Contact the retailer or service center for the information on recommended
computers, Fibre Channel devices, or Fibre Channel cables.
Refer to the user's manual of the product for information on how to setting
Fibre Channel device.
6.
Plug the power cord of the Fibre Channel device into the electrical outlet. For detailed
information, refer to the “Maintenance guide” of the Fibre Channel device.
7.
Plug the power cord of the computer into the electrical outlet.
4-4. Installing the Driver
To use this product, the appropriate Fibre Channel driver for your operating system must be installed.
For detailed information, refer to the “Maintenance guide” of the computer.
7LSV
