Pay attention to hot surface.
Immediately after the server is powered off, its internal components such as hard disk
drives are very hot. Leave the server until its internal components fully cool down
before installing/removing any component.
Insert the board firmly.
Connect the board into PCI slot securely. Loose connection may cause fumes or fire.
Insert the power plug into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug/cable (imperfect contact)
may cause a fire. Heat will also be generated if condensation is formed on dusty
blades of the halfway inserted plug, increasing the possibility of fire.
Do not hold the power plug with a wet hand.
Do not disconnect/connect the plug while your hands are wet. Failure to follow this
warning may cause an electric shock.
Do not use any unauthorized interface cable.
Use only the interface cable that comes with your server. Use of an unauthorized
interface cable may cause a fire when the electric current exceeds the rated flow.
Also, observe the following to prevent an electric shock or fire caused by a damaged
cord.
¾
Do not use any damaged cable. (Replace a damaged cable with a new one of the
same specifications. Ask your sales agent for replacement.)
¾
Do not step the cable.
¾
Do not place any object on the cable.
¾
Do not alter, modify, or repair the cable.
When disconnecting a cable, hold the connector, and pull it out straight.
Use only the Fibre Channel cable authorized by NEC and connects it to the proper
connector.
Ignoring these instructions may cause a short circuit, resulting in a fire, electric shock,
or malfunction.
Do not use a cellular phone or pager around this product.
Turn off the cellular phone or pager. Radio interference may cause malfunctions of this
product.
Do not use the product in an environment where corrosive gas is present.
Do not install the product in a place subject to corrosive gases including sodium
chloride, sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, or
ozone. Do not install the product in an environment that contains dust, chemicals that
accelerate corrosion such as NaCl or sulfur, or conductive materials. Failure to follow
this warning may cause the wiring on the printed circuit board to short-circuit, leading
to fire. If you have any questions, contact your maintenance service company.
&$87,21
