1. Error Message
Express5800/R120d-1E, R120d-2E Maintenance Guide
140
Chapter 3 Appendix
(2) Error reporting via beep
Even if an error is detected by POST, the error message may be unable to be displayed in the display. In this
case, the server beeps to report that an error has occurred.
For example, the beep code 1-3-3-1 indicates 1 beep, a pause, 3 beeps, a pause, 3 beeps, a pause, and 1 beep,
which means that an error occurred while checking the memory capacity.
The table below shows the beep code, description, and solution.
Beep Code
Description
Solution
1-3-3-1
No memory module is not installed.
Or, no memory is detected.
Make sure that the DIMMs are correctly
inserted.
If this does not resolve the problem, contact
your sales representative.
1-5-2-1
The processor is not installed.
Or, no processor is detected.
Make sure that the processor is correctly
mounted. If this does not resolve the problem,
contact your sales representative.
1
POST detected an error.
Contact your sales representative.
2
Updated BIOS data was detected.
This is not an error.
Wait until BIOS update completes.
3
Failed to read BIOS data.
Or, failed to execute BIOS.
4
Failed to initialize the BIOS executable
module.
5
No graphics controller could be detected.
7
Failed to reset the system.
Contact your sales representative.
8
An error was detected when allocating the
PCI resources.
Remove all the installed PCI boards to PCI
slots, and then reboot the server.
If the same error is detected repeatedly,
contact your sales representative.
