English-14
USB-C port functions
The equipped USB-C port supports the following functions. These three functions can be used concurrently, however, the actual
behavior depends on the function and specification of the connected USB-C device. You can check the status of the actual
functions on the “USB-C information” OSD.
Video and audio input
Supports DisplayPort input (DisplayPort Alt Mode on USB Type-C). Supports RGB 10bit signal and DisplayPort multistream
(see
page 19
).
NOTE:
This function is available when the connected USB-C device complies with DisplayPort Alt Mode on USB Type-C.
Please use a USB-C cable that complies with USB3.1 Gen.1 or Gen.2.
Power supply (see
page 28
)
Charges a connected USB device (USB Power Delivery).
NOTE:
- This function is available when the connected USB-C device complies with USB Power Delivery.
- The maximum power supply is 30 W but it changes depending on the connected device and cable.
You can check the power voltage and current information in the OSD.
If the connected device does not comply with USB Power Delivery or the device is not recognized,
the information shows “---”.
In this case, the power might be supplied as complies with USB Type-C power delivery depending on the type of
connected devices and cables.
- Please use a USB-C cable that complies with USB Power Delivery.
USB hub function
Allows using USB devices that are connected to the USB down stream port of the monitor.
NOTE:
- If a signal is sent to the USB input that is beyond the recommended signal timings, even if the device complies
with USB3.1 Gen.1, it might be connected as USB2.0.
In this case, the USB hub is disconnected temporarily when changing between USB3.1 Gen.1 and USB2.0.
- The USB hub is disconnected temporarily when changing the setting of SST (Single-Stream Transport) to
MST (Multi-Streaming Transport).
Please remove the USB device before changing the setting.
NOTE:
Information about the tested USB-C devices and cables are on the NEC Display Solutions website.
For safety and reliability purposes, it is highly recommended that only the tested cables be used.
