4-24 Upgrading Your System
Cabling the Disk Drives
Removing an Internal Hard Disk Drive
1.
Power off the system and remove the left side panel as described
earlier in this chapter.
2.
Disconnect the signal and power cables from the back of the drive. It
is necessary to completely remove the cables from all the drives
before the drive can be removed.
3.
Remove the three screws holding the 3.5-inch drive bay to the
chassis.
4.
Swing the drive bay out of the chassis.
5.
Slide the drive bay towards the top of the chassis until the tabs on
the bay are free from the chassis. Remove the drive bay from the
chassis and place it on an antistatic surface.
6.
Remove the hard disk drive by removing the four screws that secure
the drive to the drive bay.
7.
Replace the 3.5-inch drive bay. Insert the tabs into their slots on the
chassis. Slide the drive bay towards the bottom of the chassis until
the tabs hit their stops.
8.
Connect the signal and power cables to the drives.
Note:
Verify that all cables are seated and routed properly.
9.
Replace the three screws securing the drive bay. Replace the left side
panel and power on the system.
10.
Remove the drive serial number from the equipment log.
1
2
4
3
Summary of Contents for LS2400
