4-10 Upgrading Your System
1.
Power off the system and remove the left side panel as described
earlier in this chapter.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap. Hold
the processor only by its edges.
2.
Press the processor latches toward the center of the S.E.C. cartridge
to free them from the retention module (A).
3.
Lift the S.E.C. cartridge upward, out of the retention module.
4.
Put the processor in a piece of conductive foam and store in an
antistatic package.
Removing a Processor
5.
Proceed to the next section, “Installing the Pentium II Processor.”
Installing the Pentium II Processor
1.
Power off the system and remove the left side panel as described
earlier in this chapter.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap. Hold
the processor only by its edges.
2.
If your system has one processor and you are adding a second
processor, then you must remove the termination board in the
empty Slot 1 secondary connector. Press the tabs on the top of the
termination board bracket (A in figure) toward each other to release
them from the retention module. Lift the board bracket and the
terminator board (B) up and out of the retention module, and store it
appropriately.
Summary of Contents for LS2400
