4-12 Upgrading Your System
Assembling the Pentium II Processor
9.
Position the processor so that the heat sink faces the center of the
system board. Slide the processor into the retention module.
Ensure that the alignment notch in the S.E.C. cartridge fits over the
plug in Slot 1. Push down firmly, with even pressure on both sides
of the top, until the S.E.C. cartridge is seated.
10.
To lock in the processor, push the latches outward until they click
into place in the retention module (A in figure, below). The latches
must be secured for proper electrical connection of the processor.
Locking in the Processor
11.
After you have installed a new processor, you must run the BIOS
Setup Utility (F2) to configure its speed. Refer to Chapter 3,
“Configuring Your System.”
12.
Replace the left side panel and power up the system.
Summary of Contents for LS2400
