5-14 Problem Solving
Enable F2 Prompt by Using SSU
1.
Insert your SSU diskette in the diskette drive. This is the diskette
that is created by copying the SSU software from E
XPRESS
B
UILDER
CD-ROM that comes with the system.
2.
Reboot the system by pressing
Ctrl+Alt+Del
while at the DOS
operating system prompt
or
by pressing the reset switch.
3.
When the DOS Startup menu appears, select 1 or 2 to enter the
SSU.
4.
Select Step 3, “Change Configuration Settings.” If a password menu
displays, enter a user or administrative password if either is
enabled, or just press
ESC
to bypass this menu prompt.
5.
Select the System Board.
6.
Page down until you reach the Boot Subsystem Group. It is toward
the end of the groups.
7.
Find and select the option that says, “Display ‘F2 for Setup’ Message
during POST.”
8.
Press
Enter
to display the option menu.
9.
Select
Enable
and press
Enter
.
10.
If you are finished editing the settings for the system board, press
Esc
. This takes you back up to the main menu, Step 3.
11.
Press
Esc
again to return to the main SSU menu.
12.
Select Step 4, Save Configuration. Once you select this step, the
changes are immediately saved into an INF file, a CMS file, and
nonvolatile memory.
13.
Press
Esc
to exit the SSU. You will be prompted to reboot the
system or simply exit to the command line prompt. You’ll need to
reboot the system to let your changes take effect, but
first
remove
the SSU diskette drive.
Then
press
F10
to reboot.
You should now see the
F2
prompt displayed at bootup.
Summary of Contents for LS2400
