2. SYSTEM BIOS –SETUP–
Chapter 3 Setup
2.
SYSTEM BIOS –SETUP–
This section describes how to configure Basic Input Output System (BIOS).
Before you install the server and add or remove optional devices, make sure you have read and understood this
section to configure properly.
2.1
Overview
The SETUP utility is provided to make basic hardware configuration for the server. This utility is pre-installed in
the flash memory of the server and ready to run.
SETUP was configured for optimal performance before the server was shipped. Therefore, in most of cases,
you do not need to use the SETUP utility.
Use only when the case applies to any of cases described in
Chapter 3 (2.4 Cases that Require Configuration)
.
2.2
Starting and Exiting SETUP Utility
2.2.1
Starting SETUP
Run POST following
Chapter 3 (1.1.1
Flow of POST
)
.
After a while, the following message will be displayed on the lower left of the screen. (The on-screen message
depends on your system environment.)
Press <F2> SETUP, <F4> ROM Utility, <F12> Network
If you press <F2> key at this time, SETUP runs and displays
Main
menu upon completion of POST. (You can
also press <F2> key to display
Main
menu while option ROM is expanded.)
Password
If password is set, you will be prompted to enter password.
Enter Password [ ]
Up to three password entries are accepted. If you enter incorrect password consecutively three times, the
system halts (you can no longer proceed).
In this case, power off the server once, then power it on.
2.2.2
Exiting SETUP
To exit SETUP after saving parameters, select
Save & Exit
→
Save Changes and Exit
.
To exit SETUP without saving parameters, select
Save & Exit
→
Discard Changes and Exit
.
Tips
To restore the default value, select
Save & Exit
→
Load Setup Defaults
.
(The default value might be different from the factory setting.)
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 User's Guide
86
Summary of Contents for Express5800/R320d-M4 Series
