NEC Express5800 120Lh, User Manual, Page: 208 / 314

8-34 Troubleshooting
7.
If the optional board or SCSI HostRAID is installed, select the proper SCSI Adapter and
press
Enter .
– Adaptec HostRAID U320 Driver Ver 1.02 For Windows 2000/XP/2003 (When SCSI
HostRAID is installed.)
– INITIO INI-A10XU2W SCSI Host Adapter (When N8103-65F board is installed.)
– MegaRAID SCSI 320-1 Controller Driver (When N8103-80F board is installed.)
– MegaRAID SCSI 320-2 Controller Driver (When N8103-81F board is installed.)
– Adaptec I2O RAID Driver Disk for 32bit Windows 2000/XP/2003 (When N8103-86F
board is installed.)
8.
Press R to select the recovery option.
9.
Select the keyboard.
10.
If you are requested, press R to select system recovery procedure.
11.
If you are requested, select either of the procedure below:
[Manual Recovery] (Press
M
)
Do not select this option unless you are a high-level user or a system administrator.
If you use this option, you can recover the problems of system files, partition boot
sector, and start-up environment.
[Quick Recovery] (Press F )
This option is very easy to use and the user does not need to do anything during the
procedure. If you select this option, the system recovery disk program starts to
recover the problems concerning system files, partition boot sector of system disk,
and start-up environment (if multiple operating systems are installed on the system).
12.
Follow the instruction displayed on the screen, and then press L at the screen which
request you to insert system recovery disk. The system will be restarted once.
NOTE:
Starts the procedure without system recovery disk.
13.
Repeat steps 1 to 10.
The recovery procedure will be started.
During the recovery, the missing files and the damaged files are replaced either to the files
in C:\ I386 folder of hard disk or the files in systemroot\ Repair of the system partition.
These replaced files do not reflect the changes of the configuration after the setup at all.
14.
Follow the instruction displayed on the screen.
If you take a note of any file name in which trouble is detected during the procedure, it is
useful to diagnose how the system has been damaged.
15.
Terminates the procedure if the recovery is successful.
You can verify that the replaced files are correctly copied to the hard disk if the computer
is restarted normally.