2-8 Setup Utility
Legacy USB Support
This option configures support for legacy USB devices. Select “Enabled”
or “Disabled.”
To return to the Advanced Menu, press
Esc
.
IDE Configuration Submenu
This submenu can be used to auto-configure or manually configure the IDE
devices, usually hard drives or CD-ROM drives. Depending on the system you
purchased, the available options may include “User,” “Auto,” “CD-ROM,”
“ATAPI Removable,” “IDE Removable,” or “None.”
The standard hard drive (drive C) shipped with the system is configured as
“Primary IDE Master.” The standard CD-ROM drive is configured as
“Secondary IDE Master.” To display the submenu for an IDE device, highlight
the appropriate device field and press
Enter
.
Note:
Jumpers on the IDE device must be set to the
master or slave device (see the documentation that comes
with the device).
IDE Controller
This option configures the system’s integrated IDE controller. Select
from “Primary,” “Secondary,” “Both,” or “Disabled.”
Hard Disk Pre-Delay
This option set the time delay to allow the hard drive to spin up. The
choices in seconds are “3,” “6,” “9,” “12,” “15,” “21,” and “30.”
These entries let you check or change the following hard drive parameters. They
are not available if “Auto” is selected.
Type
This field lets you select the drive type. Available options include “User,”
“Auto,” “CD-ROM,” “ATAPI Removable,” “Other ATAPI,” “IDE
Removable,” or “None.”
Maximum Capacity
This field displays the maximum capacity of your hard drive.
