78K0/Fx2 – CAN it!
(7)
[Autoprocedure(EPV)] command execution
Select [Device]
→
[Autoprocedure(EPV)] from the menu bar.
When the [Autoprocedure(EPV)] command is executed, Blank Check
→
Erase
→
Program and
FLASH Internal Verify are executed sequentially for the
μ
PD78F0893 device.
Figure 64: After EPV Execution
"...finish" is displayed.
(8)
Terminating the GUI
Select [File]
→
[Quit] to terminate the GUI software. All settings executed so far are saved in the
FPL3.INI file, so that those settings can be reused when the GUI software is restarted.
(9)
Execute “ADC_DEMO” application
Set the
78K0/Fx2 – CAN it!
board to the normal operation mode by switching SW4/S1 to OFF.
< Plug and Play> the
78K0/Fx2 – CAN it!
board to start in normal operation mode or press the
reset button SW1 to release the normal operation mode.
(10) Restarting the GUI
When the system is restarted, the same screen as shown in Figure 62 appears.
66
