78K0/Fx2 – CAN it!
(3) [Program] command
The [Program] command sends a specified user program to the target device and
writes the program to the flash memory.
The execution of Verify operation for detecting an error in user program
communication from the FPL3 to the target device after the execution of the [Program]
command follows the setting of the 'Command options' on the Advance tab displayed
by selecting [Device]
→
[Setup].
During programming, the progress status is displayed in the action log window to
indicate programmer operation. This progress status display window displays the
progress status on target device programming by percentage.
Upon completion of [Program] command execution, the GUI software displays the
result of executing the command on the target device.
(4) [Verify] command
The [Verify] command sends a specified user program to the target device connected
with the FPL3, and performs verification against the data written to the flash memory
of the target device.
During verification, the progress status is displayed in the action log window to
indicate programmer operation. This progress status display window displays the
progress status of target device verification by percentage.
Upon completion of [Verify] command execution, the GUI software displays the result
of executing the command on the target device.
(5) [Security] command
The [Security] command initiates the programming of the security flag of the target device
connected to the FPL3. Set ‘Security flag settings’ on the Advance tab of the [Device] >
[Setup…] menu.
(6) [Checksum] command
The
[Checksum] command reads the checksum value of the target device connected with
the FPL3.
This value differs from the value displayed in the parameter window of the main window.
(7) [Autoprocedure(EPV)] command
The [Autoprocedure(EPV)] command executes the [Erase] command, [Program]
command and [Verify] command in succession.
When a user program is to be resent to the target device for comparison with the data
written to the flash memory of the target device because of a user program
communication error, execute the [Program] command by selecting [Device]
→
[Setup] and specifying 'Command options' on the Advance tab, then set the automatic
execution of the [Verify] command.
During EPV execution, the progress status is displayed in the action log window to
indicate programmer operation. For a selected command, its execution operation,
and messages, refer to
CHAPTER 10 HOW TO USE FPL3
.
Upon completion of [Autoprocedure(EPV)] command execution, the GUI software
displays the result of executing the command on the target device.
(8) [Signature read] command
The
[Signature read] command reads the signature information (device name, flash
memory information, and so forth) of the target.
49
