NC1600C
Important Information
D-5
• Shut down AC power to the projector and
disconnect all the cables before moving
the projector to another place.
• Consult your dealer for installing the power
cable to the projector. DO NOT install the
power cable by yourself.
Doing so may cause a fire or electric shock.
• To carry the projector, a minimum of five
persons are required. Remove the lens
and the lamp before carrying the projector.
Do not apply a strong shock to the projector.
Do not hold the lens part and the anamorphic
lens part with your hand. Otherwise the
projector may tumble or drop, causing
personal injury.
• If the projector will not be used for an
extended period of time, shut down AC
power.
• Shut down AC power by using a circuit
breaker before cleaning.
• Do not try to touch the ventilation outlet
as it can become heated while the projector
is turned on. Doing so can lead to burning
your hands due to the emitted heat.
• When main body is damaged, cooling fluids
may come out of internal part. DO NOT
touch and drink the cooling fluid. When
the cooling fluids are swallowed or contacted
with your eyes, please consult with doctors
immediately.
• When using a LAN cable:
For safety, do not connect to the connector
for peripheral device wiring that might have
excessive Voltage.
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it
dry immediately.
• Avoid excessive heat and humidity.
• Do not heat, take apart, or throw batteries
into fire.
• If you will not be using the remote control for
a long time, remove the batteries.
• Ensure that you have the batteries’ polarity
(+/-) aligned correctly.
• Do not use new and old batteries together, or
use different types of batteries together.
• Dispose of used batteries according to your
local regulations
Installation
• Do not put the projector on its side when
the lamp is on. Doing so may cause damage
to the projector.
• Controlled ambient light environments will
allow for an image of higher contrast and
depth to be displayed.
•
Screens with a soiled, scratched, or
discolored area will not produce a clean
image. Care should be used in the handling
of the screen.
• To carry the projector, a minimum of five
persons are required.
• Keep finger prints or dust off the lens
surface. Leaving finger prints or dust can
cause unwanted shadows on the screen.
Cover the lens with the supplied lens cap
if the projector is not to be used for an
extended period of time.
Lamp Caution: Please read before
operation
• Due to the lamp being sealed in a pressurized
environment, there is a small risk of
explosion, if not operated correctly. There is
minimal risk involved, if the unit is in
proper working order, but if damaged or
operated beyond the recommended hours,
the risk of explosion increases. Please
note that there is a warning system built
in, that displays following message when
you reach a preset operating time “Bulb
Over Time”. When you see this message
please contact your dealer for a replacement.
If the lamp does explode, smoke will be
discharged from the vents located on the
back of the unit. Do not stand in front of
the vents during the operation. This smoke is
comprised of glass in particulate form
and Xenon gas, and will not cause harm
if kept out of your eyes. If your eyes have
been exposed to this gas, please flush your
eyes out with water immediately and seek
immediate medical attention. Do not rub
your eyes! This could cause serious injury.
• Do not shut down AC power to the projector
under the following conditions. Doing so
can damage the projector:
- While projecting images
- While cooling after the lamp has been
turned off. (The POWER indicator blinks in
orange while the fan is rotating, and
the LCD screen is displaying "cooling...".
The cooling fun continues to work for
5 minutes).
