Neat WALL Famiy, Technical Handbook

Page: 18 / 56

neat
18
NE41 11014-02 v4.1 WALL - Technical Handbook
3.7 Manual configuration
These units can be manually configured regarding adding radio transmitters and how
the two relay outputs should act when the added transmitter is activated.
The procedure is in short:
1. Determine what position to activate.
2. Add the radio transmitter.
3. Determine the action when the added transmitter is activated.
3.7.1 Add a radio transmitter
Please read the following instruction carefully before attempting to manually
configure a radio transmitter.
1. Power off the unit (both 24 V
DC
and batteries must be removed).
2. Remove jumper J2.
3. Power on the unit and replace jumper J2 within 5 seconds from power on.
4. The LED1 now blinks green three times.
5. After the initial “three green blink”, the unit will now start to blink red. The number of
blinks indicates the currect radio position, i.e. 3 red blinks equals radio position
3.
1 2 3 4 5 6 7 8 1 2
Picture 12. Sequence
6. To select radio position, press any button.
7. The unit confirms the selection by lighting green for 2 second.
8. Now activate the radio transmitter (e.g. press the red button on an ATOM).
9. The unit confirms the succesful reception of the radio ID code by lighting green
for 2 seconds.
10. The unit starts blinking green, allowing the setting the action for relay 1.
11. The number of blinks indicate what action to set.
–
1 blink = Pulse
–
2 blinks = On
–
3 blinks = Off
–
4 blinks = Toggle
–
5 blinks = No action
–
6 blinks = Stop pulse
12. Press any button at the appropriate action blink.