NCR SelfServ XK32, Installation Manual

Page: 22 / 251

2-12 Hardware Installation
Installation Guidelines and Restrictions
• Before installing the unit, read and follow the guidelines in the NCR SelfServ™ XK32
(2247) Site Preparation (BCC5-0000-5377) and the NCR Workstation and Peripheral AC
Wiring Guide (BST0–2115–53).
• Install the terminal near an electrical outlet that is easily accessible. Use the power
cord as a power-disconnect device.
• Do not permit any object to rest on the power cord. Do not locate the terminal
where the power cord can be walked on.
• Use a grounding strap or touch a grounded metal object to discharge any static
electricity from your body before servicing the terminal.
• If the power cord is replaced, it must be replaced with the same type of cord with
the protective shroud.
• Do not route the power cord through openings with sharp edges.
Caution: The units contains hazardous voltages and should only be serviced by
qualified service personnel.
Caution: Due to the weight of the NCR SelfServ XK32 kiosk, the following is required
to install the kiosk:
• A
minimum of two persons
for Single–sided or Wall Mount kiosk configuration
• A minimum of three persons for Double–sided kiosk configuration