Controls / Features
5
Stop the vehicle and wait shortly. The End Calibration message should reappear on
the display.
6
Push and
HOLD
the display control knob until the End Calibration command disappears.
The calibration should now be complete.
IMPORTANT!: Just pressing and failing
to hold the display control knob inward until the End Calibration command
disappears will cancel the calibration procedure and you must start over at Step 1.
7
Test the compass calibration. Turn the vehicle ignition key OFF and then restart the
vehicle. Wait 10 seconds for the compass to complete its self test. Drive the vehicle in
a circle and note the compass readings.
•
If the lower left quadrant of the Instrument Panel Gauge Cluster Display shows the
correct compass / vehicle heading, the compass calibration is now complete.
•
If the compass readings are incorrect, inspect for correct Declination Zone number,
turn OFF the vehicle, restart the vehicle, wait 10 seconds, and perform another
circle while periodically noting the compass readings.
•
If readings are still incorrect, restart the compass calibration procedure.
65
Summary of Contents for ProStar+
