11
16. Use fingers to remove the Console Data Cable as shown.
17. Guide cable out of the Hand Bar tube while pulling on cable outside.
18. Installation is the reverse of this procedure. If necessary, a flexible wire can be used to help install the data cable through the Hand Bar and upright tubing.
Replacing the Console Electronics
!
To reduce the risk of electrical shock, always unplug the power cord and wait 5 minutes before cleaning, maintaining or repairing this machine.
Tools Required: #2 Phillips Screwdriver, 5 mm hexhead wrench
1. Remove the 4 screw plugs (R) .
2. Remove the 16 indicated retaining screws(P) from each side using a Phillips
screwdriver.
3. Remove the outer Upright Covers by pulling at the center and flexing outward. Set them aside.
#2
P
X16
X4
R
#2
P
X16
X4
R