NanoSense E4000NG, Installation Manual

Page: 2 / 27

Guide d’Installation sonde E4000
E4000 probe Installation Guide
www.nano-sense.com All Rights Reserved Tel: 33 (0)1 41 41 00 02 page 2/27
Summary
1. Security 3
2. Positioning 3
3. Installation 4
4. Wiring 4
5. Motherboard preparation 4
5.1. RS485 4
5.2. Optional Bus board 5
5.2.1. Install the daughter board 5
5.2.2. Mount the BUS connector 5
5.3. Analog Option 5
5.4. LED Option 5
5.5. EnOcean Option 6
5.6. Gateway EnOcean-KNX Option 6
6. Install the motherboard into the case 6
6.1. Temperature sensor 7
6.1.1. Standard positioning 7
6.1.2. High performance positioning 7
7. Connecting 7
7.1. Power Supply 7
7.1.1. Power Supply Characteristics 7
7.1.2. Power supply connection 9
7.1.2.1. RS485, Analog, EnOcean, KNX and LON 9
7.2. Connecting to ventilation and other elements 10
7.2.1. RS485 10
7.2.2. Analog Option 10
7.2.3. KNX or LON Sensor Mode 10
7.2.4. EnOcean sensor mode option 11
7.2.4.1. Pairing 11
7.2.4.2. Telegram Transmission Principle 11
7.2.4.3. Description Radio Telegram 11
7.2.4.4. Transmission Range 12
8. Insert gas sensors 14
8.1. Sensor on mini SD card 14
8.2. CO2 single band NDIR Sensor 14
8.3. CO2 double band NDIR Sensor 14
9. Powering 15
10. Threshold settings (EnOcean, Modbus RS485 and Analogical Board) 16
10.1. Position the micro switches 16
10.2. RH (humidity) threshold settings with LCD tool 17
10.3. CO2 Baselines expressed in ppm 18
10.4. Guide values for VOCs 18
11. Type of VOC measure settings 19
12. Connection diagram according to position of micro switches 20
13. Completion of installation 21
14. Summary of Simultaneous Configurations 21
ANNEXES 22
1. Installation of BUS connections 22
1.1 RS485 22
1.2 Programming the physical address 23
1.3 Choice between RTU and ASCII 23
1.4 RS485Annexes probes 23
2. Choosing Cable Bus 24
2.1. RS485 24
2.1.1. Topology 24
2.2. KONNEX 24
2.3. LONWORKS 24
3. Ventilation Control 25
4. Specification 26
DRILLING 27