Guide d’Installation sonde E4000
E4000 probe Installation Guide
www.nano-sense.com
All Rights Reserved
Tel: 33 (0)1 41 41 00 02
page 10/27
Note: KNX or LON EnOcean Gateway
Connecting the EnOcean module enables the gateway function between KNX or LON and EnOcean.
In addition to the gateway function, this module is used to enrich the functions between the EnOcean
sensors and EnOcean actuators by KNX or LON settings. The pairing between the gateway and
EnOcean devices requires prior setting of KNX or LON communication object via ETS or LON tool.
The pairing is then made through the buttons of the LCD tool panel.
For detailed on settings, refer to the KNX or LON setting manual.
Without wired bus interface board, the probe becomes an EnOcean sensor.
7.2.
Connecting to ventilation and other elements
7.2.1.
RS485
7.2.2.
Analog Option
See bridge diagrams on chapter 0
7.2.3.
KNX or LON Sensor Mode
Liaison with HVAC and heating is by KNX or LON wire (twisted pair). HAVC, heating and air
conditioning must be compatible KNX or LON
Measures and orders are transmitted via the RS485 Modbus.
The cable must be twisted. For the selection of cable refer to
§2 Choosing Cable Bus
For more details on the connection, see annex §1 Installation of
BUS connections.
0-10V output corresponds to
VOC, CO2 and HR combined.
(See technical specification for
details)
HVAC 2
High
Speed
HVAC 1
Low
Speed
HVAC 2-1
0-10 V Output
Logic NC
Logic NO
HVAC 2-1
HVAC two speeds
HVAC continuous
HVAC one speed
+
-
N
