N&W Global Vending Canto Plus Instant, Installation Operation & Maintenance

Page: 50 / 68

© by N&W GLOBAL VENDING S.p.A.
44
07 - 2010 3375 - 01
m
ixEr NozzlEs
If it had been necessary to disassemble the instant shelf,
pay attention to the nozzle/pump combination in use
before during the reassembly phase.
assemble 1-hole nozzles in such a way that the water
inlet into the mixer will occur from the lower coupling.
any considerable variation in the doses of a drink may
require the replacement of the corresponding nozzle to
keep a correct flow rate.
Nozzles having a different flow rate are identified by the
colour and number of holes:
Nozzles flow rate
Magenta (1 hole) 9 - 11 cc
Orange (1 hole) 11 - 13 cc
Magenta (2 holes) 19 - 22 cc
Orange (2 holes) 22 - 25 cc
White (1 hole) 22 - 25 cc
If you change the nozzle, you shall set up the type of
nozzle in the software of the machine (in the pump setup
function from the technician menu).
the white nozzle is used to dispense hot water only.
at the end of the procedure, test the selections using
that mixer to be sure that the dispensing cycle of drinks
is correct.
CuP dIsPENsEr
the cup dispenser is conceived in such a way that it can
be easily disassembled for maintenance operations.
It is possible to disassemble every single column of the
cup stacker and the cup release ring without making use
of any tool.
the cup release ring shall not be opened for normal
cleaning.
If you are required to act, please follow the instructions
here below at the time of reassembly:
align the notch on the toothwheel microswitch activator -
gear with the scroll support arrow.
- observe the orientation of scrolls as it is represented by
the figure.
Fig. 27
Pump 1-
(single or double) nozzles 2-
Upper water coupling 3-
Lower water coupling 4-
Mixer 5-
Dispensed drink 6-
Fig. 28
Cup stacker 1-
Extractable column 2-
Cup release ring 3-
Toothwheel microswitch activator 4-
Reference notch 5-
Cup release scrolls 6-