© by N&W GLOBAL VENDING S.p.A.
11
07 - 2010 3375 - 01
Chapter 2
Installation
Installation and any subsequent maintenance opera-
tion must be carried out when the
machine is live
and,
therefore, by the personnel skilled and trained on the
use of the machine as well as aware of the specific risks
such a condition may involve.
the machine must be installed in a dry room, at a tem-
perature between 2° and 32°C and it can not be installed
in a room where water jets are used for cleaning (e.g.
large kitchens, etc.).
at the time of the installation, it is necessary to
completely sanitise the water circuits and the parts
in contact with foodstuffs in order to remove any
bacterium that may have built up during storage.
door swItCHEs
m
aiNs
Whenever you open the door, a special switch will power
off the electric installation of the equipment.
to power on the machine when the door is open, just
insert the key into the slot (see fig. 12).
when the door is open, you are not allowed to
access any live part. only the parts protected by
covers and marked by the label “power off before
removing the cover” will remain live inside the
machine.
before removing these covers, it is necessary to
detach the power supply cable from the mains.
You can close the door only after having removed the
key from the door switch.
D
oor
opEN
the open door signalling switch (used on some models
only) (see fig. 12) is operated by the lock by means of
the door hook device.
this switch is intended to store the door opening in the
machine statistics.
UnPaCKIng The venDIng maChIne
after having unpacked the machine, make sure that the
equipment is intact.
In case of doubt never use the equipment.
no packing material (plastic bags, foam polysty
-
rene, nails, etc.) should be left within the reach of
children since they are potential sources of danger.
Packing materials shall be disposed of in authorised
dump sites and recyclable ones collected by specialised
companies.
Important!!
the machine shall be arranged to prevent maximum
inclination from exceeding 2°.
If necessary, level it by using the adjustable feet (see fig.
13) supplied with the machine.
Fig. 12
Door switch
1-
Permanently live socket (230V~ 2 A max)
2-
Mains fuses
3-
Card LED display holes
4-
Counter
5-
Door opening signalling micro (optional)
6-
Service buttons.
7-
Fig. 13
Adjustable foot
1-
Summary of Contents for Canto Plus Instant
