NAMCO Prop cycle, Operator'S Manual

Page: 22 / 59

Page 22
6. INITIALIZATION
Adjustments When Replacing Parts (Initialization)
The following adjustments should always be performed after replacing the
game PC board, ROM, Steering Assy, Pedal Assy, or Control Pots.
The game will not operate correctly if these adjustments are not made.
a) Ensure that handle bar assembly is in the neutral position by keeping your
hands away from the assembly.
b) Slide the test switch “ON” while pressing the service switch. The following
screen will be displayed on the monitor.
c) Press the service switch to reset all values to 0000 or FFFF
f) Slide the test switch “OFF” to return to normal game mode.
Note: If the above initialization does not perform correctly, repeat two or
three times.
ADJUST MODE
BASE BIAS VALUE
UP / DOWN ; 0252 0258 0000
RIGHT / LEFT : 0252 0257 0000
ADJUST HANDLEBARS PRESSING
SERVICE SWITCH
TO EXIT : TURN OFF TEST SWITCH