NAMCO Prop cycle, Operator'S Manual

Page: 10 / 59

Page 10
4-2 Connecting the Cycle Assy to the Monitor Cabinet
1, Connect the connectors between the Cycle Assembly And the Monitor
Cabinet.
2. Remove 2off Hex Head Set Screws (M8x25), Spring and Flat Washers on
each Joint Bracket, turn the Bracket over and refit, finger tight, using the
same screws and washers.
3. Push the Cycle Assembly fully up to the Monitor Cabinet, taking care not
to trap any wires.
4 Fit the Joint Brackets, finger tight, to the Monitor Cabinet using 2off Hex
Head Set Screws (M8x25), Spring and Flat Washers for each bracket.
When all screws have been located, tighten all the screws fully.
NOTE:-
When the machine is fully assembled and in its final position, lower the 8 level
adjusters, (4ea on the Monitor cabinet and Cycle Assy), with a spanner so that
the machine is level and all castors are raised from the floor by approx. 5mm.
Tighten the lock nuts with a spanner to ensure that the level adjusters do not
move.