NAL Research Corporation (451-93156-002A)
77
<key>:
The key that must be enclosed by two single quotes (‘ ‘). This can only have
characters 0-9 or A-F and must be 64 bytes long. For example,
‘0102030405060708090A0B0C0D0E0F101112131415161718191A1B1C1D1E1F20’.
A.8.127 ^KE – Key for Encryption (Encryption)
Exec Command: ^KE=<password>,<key>
Allow entering the 32 bytes for the AES encryption key. These bytes must be entered with
mandatory leading 0s, where each byte is represented by 2 hexadecimal uppercase characters
for a total of 64 digits. The password and key will not be reset by &F. The password and key will
not be echoed. This command must be entered twice before an update is made.
NOTE: The Encryption key must match the Decryption key at the base station or NOC.
<password>: The Crypto Officer Password must be enclosed by two single quotes (‘ ‘). The
Crypto Officer Password must be changed from its factory-set value before this
command will work.
<key>:
The key that must be enclosed by two single quotes (‘ ‘). This can only have
characters 0-9 or A-F and must be 64 bytes long. For example,
‘0102030405060708090A0B0C0D0E0F101112131415161718191A1B1C1D1E1F20’.
A.8.128 ^KZ – Key Zeroization (Encryption)
Exec Command: ^KZ=<password>
Reset or zeroize the encryption and the decryption keys and stop encryption until the keys are
re-entered with the AT^KD and AT^KE commands.
<password>: The Crypto Officer Password must be enclosed by two single quotes (‘ ‘). The
Crypto Officer Password must be changed from its factory-set value before this
command will work.
A.8.129 ^MODRSTn – Modem Reset Information Message Displayed
Whether to display the information message ^MODRST:1 when the modem is automatically
recovered. Command has read.
0
Information message is not displayed
1
Information message is displayed.
A.8.130 ^MPTDC- Modem Power Toggle Data Connection
Exec Command: ^MPTDC =
[<mode>]
Enable or disable the modem power toggle functionality during a data connection. When in a
data connection, after there has been a four minute period of inactivity, there will be a check
sent to determine if the modem is still responding. If it is not, the modem will power cycle and
return in command mode.
<mode> takes the following values:
0 Disable the MPT functionality during a data call.
1 Enable the MPT functionality during a data call.
Read Command: ^MPTDC?
