NAD C325BEE, Owner'S Manual, Page: 9 / 82

9
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
PROBLEM CAUSE SOLUTION
NO SOUND • Power AC lead unplugged or power not
switched on • Check if AC lead is plugged in and power
switched on
• Tape 1 Monitor selected • De-select Tape 1 Monitor mode
• Mute on • Switch off Mute
• Rear Pre-out/Main-in amp links not fitted • Fit links
• Headphones inserted • Disconnect headphones
NO SOUND ONE CHANNEL • Balance control not centered • Center Balance control
• Speaker not properly connected or damaged • Check connections and speakers
• Input lead disconnected or damaged • Check leads and connections
WEAK BASS / DIFFUSE STEREO IMAGE • Speakers wired out of phase • Check connections to all speakers in the system
REMOTE CONTROL HANDSET
NOT WORKING • Batteries flat, or incorrectly inserted • Check or replace batteries
• IR transmitter or receiver windows obstructed • Remove obstruction
• IR receiver in direct sun or very bright ambient
light • Place unit away from direct sun, reduce amount
of ambient light
POWER/PROTECTION LED TURNS RED
DURING OPERATION • Amplifier has overheated • Turn amplifier off, make sure ventilation slots on
top and bottom of amplifier are not blocked.
After amplifier has cooled down, turn back on
• Overall impedance of loudspeakers too low • Ensure the overall loudspeaker impedance is not
below 4 ohms
TROUBLESHOOTING
PRESS IN AND LIFT TAB TO REMOVE
BATTERY COVER OUT FROM RECESS
PLACE BATTERIES INTO OPENING. ENSURE
THE CORRECT POLARITY IS OBSERVED
REPLACE BATTERY COVER BY ALIGNING AND
INSERTING THE TWO TABS INTO THE HOLES.
PRESS BATTERY COVER INTO PLACE UNTIL IT
'CLICKS' CLOSED
C325BEE English.qxd 3/1/2006 2:43 PM Page 9