Nabco GT20, Wire And Programming Manual

Page: 40 / 43

40 of 43
GT20 Wire and Programming Manual www.NabcoEntrances.com
P/N C-00140 Rev 5-7-18
Table 23
Power Table
No Description Cause Elimination Checking Time Reaction
E30 01 30 V Error 30 V too low Mains failure, overload motor
Check 115 VAC line. Replace
hardware
Permanent A
02 30 V too high
03 Error upon switching-on After Power Up
E31 01 24 V General Error upon switching-on Overload, short-circuit of the 24 V
inputs
(without electric lock, Safety
Sensors)
After Power Up A
(Restart after
10 s) 02 Over-resp under-voltage Permanent
E32 01 24 V Safety Over-resp under-voltage Overload, short-circuit Safety
Sensors
E33 01 24 V E-Lock Error:
Over-resp under-voltage
Overload, short-circuit electric lock
02 Premonition:
Over-resp under-voltage
W
E34 01 24 V CAN Over-resp under-voltage Overload, short-circuit external
power supply CAN
Table 24
Option
No
Description Cause Elimination Checking Time Reaction
60 00 Relay PCB 0 Option PCB has been removed,
its address changed or became
defective
X X
Check if the option is provided.
X X
If defective: Replace or remove
from the configuration.
Permanent W
10 Relay PCB 1
W
20 Radio PCB W
30 Fire-Protection A
Table 25
System
No
Description Cause Elimination Checking Time Reaction
E50 01-99 System Error Unexpected hardware or
software event
Switch the drive unit Off/On
Carry out a Factory Reset,
carry out a Software Update,
inform the manufacturer
Permanent W or H or F
E51
E52
Table 26
Closing Sequence / Interlock Function
No
Description Cause Elimination Checking Time Reaction
70 xx CAN bus setting CAN address xx existing
twice
Correctly define the role of the
Closing Sequence or the
Interlock Function
Permanent W
E71 01 CAN connection No CAN connection
X X
Plug in, check or replace the
CAN cable
X X
Check if all the CAN participants
are switched on
Permanent W