Nabco GT20, Wire And Programming Manual

Page: 26 / 43

26 of 43
GT20 Wire and Programming Manual www.NabcoEntrances.com
P/N C-00140 Rev 5-7-18
SECTION 9 .1: The Home Page
>##<
E50
DN 1253
TOP HALF
BOTTOM HALF
9 .1 .1 Top Half of Home Page
X
Displays the Door Panel position - in real time. For example: If the Door Panel is closed and locked
the >##< will be displayed. For example: If the Door Panel is programmed to stay open for (5) seconds before closing,
the Door Panel will fully open, come to a stop, and then the LCD will not only display < 5 > the LCD Display will count
down the seconds (5 - 0). At (0) the Door Panel will close.
X
Displays Door Panel Control - in real time. Example: If an Exterior Sensor is activated, the acronym (OEO) will Display.
Table 6
Door Panel Position
Display Description Display Description
<REF?> Waits for reference switch << >> Opening
< ?? > Unknown < > Open
>< Closed >> << Closing
>##< Closed and locked == Stopping
Table 7
Door Panel Control
Display Description Display Description
OEO Exterior activation sensor (Exterior Activation Signal) SER Push side door mounted sensor (Approach
Side Safety Signal)
OEI Interior activation sensor (Interior Activation Signal) SEF Door mounted sensor for obstacle detection
(Recycle Sensitivity)
KEY Activation device for NIGHT mode (External Switch Activation
Signal, Keyswitch, Card Reader, etc.)
EMY-IN Emergency Open Input (Emergency Input
Signal)
SES Swing side door mounted sensor (Swing Side Safety Signal) PUGO Push-and-Go
PRE Header Mounted Sensor on Swing Side
9 .1 .2 Bottom Half of Home Page
X
Displays what was programmed within the GT20 Control. For example: If the Door Panel was programmed to be in
Teach Mode, both the Hand icon and Up Arrow Icon will display on the lower left hand corner.
X
Displays Error messages. For example: If the setup procedure for (Teach) is not yet completed, the E11 Error message
will display on the lower right hand corner.
Table 8
Door Panel Operation
# Description
1 Program Mode (Selector Button).
Note: A frame around an Icon indicates: overriding
Operating Mode.
KEY
s E50
DN 1260
①
②
③
Swing door: in Night Mode; is opening; and communicating to
a Slave door; (1) System Error
2
X X
(m) means closing sequence - Master
X X
(s) means closing sequence - Slave
X X
(w) means Interlock
3 Active error