23 of 43
www.NabcoEntrances.com
GT20 Wire and Programming Manual
Rev 5-7-18
P/N C-00140
b. Choose between Europe/USA
Region
EU
Region
EU
Region
USA
2. Move the Joystick up or down. The Element will stop blinking and be right side up for each circumstance.
Region
US
3. Briefly push down on the Joystick. The Value will start to blink on the lower half of the screen.
4. “Rod” communicates to the Control what type of Arm is being used and whether it is inswing or outswing. Move the Joystick
to the Right or to the Left to select(1) of the following Values.
Rod
STD-PH
Rod
SLI-PL
Rod
SLI-PH
Rod
WIN-PH
Rod
DIR-PH
Rod
DIR-PL
Rod
OHC-PH
Rod
OHC-PL
5. Briefly push down on the Joystick to (OK) selection.
6. dAxis is the distance in inches between the Back Plate of Header to the Centerline of hinge. Move the Joystick Down until the
Element dAxis is displayed.
dAxis
2.8 in
7. Briefly push down on the Joystick. The Value will start to blink on the lower half of the screen.
8. Move the Joystick to the Right or to the Left to select(1) of the following Values: 0cm...25cm
a. dAxis is an approximate Value. The installation may have to be adapted accordingly.
DN 1181
Centerline of Door Pivot
or Hinge
dAxis
Moun ng Plate (op on)
+ —
dAxis
+ —
1 cm = 3/8 inch
2 cm = 3/4 inch
3 cm = 1-3/16 inch
4 cm = 1-1/2 inch
5 cm = 2 inch
6 cm = 2-3/8 inch
Figure 4
Set the dAxis
9. Ao is the opening angle of the door. The default is 95 degrees. Move the Joystick Down until the Element A0 is displayed.
Ao
90
°
10. Briefly push down on the Joystick. The Value will start to blink on the lower half of the screen.
11. Move the Joystick to the Right or to the Left to select(1) of the following Values: 20°...190°
12. Briefly push down on the Joystick to (OK) selection.
13. Move the Joystick Down until the Element LowEn is displayed.
LowEn
OFF
14. Move the Joystick to the Right or to the Left to select(1) of the following Values.
LowEn
OFF
LowEn
ON
DO NOT USE
