Nabco GT20, Wire And Programming Manual

Page: 30 / 43

30 of 43
GT20 Wire and Programming Manual www.NabcoEntrances.com
P/N C-00140 Rev 5-7-18
Element Default Value Description
LockAU UNLOCK UNLOCK/
LOCK
X
X
Sets the condition of the lock when in Automatic mode.
X
X
Only visible when Unlock is set to PERMAN
LockEX LOCK UNLOCK/
LOCK
X X
Sets the condition of the lock when in EXIT mode.
X X
Only visible when Unlock is set to PERMAN
LockMA UNLOCK UNLOCK/
LOCK
X X
Sets the condition of the lock when in MANUAL mode.
X X
Only visible when Unlock is set to PERMAN
LcdDir 0 0...1 Orientation of the display (LCD direction)
MovCon OFF OFF/ON Endurance test Open/Close (moving continuous)
Pre Sen N.C. OFF/N.C./
N.O.
Swing side presence sensor output logic
OExMAN ON OFF/ON
X X
ON” enables activation to reopen the door during the closing cycle of a manual opening.
X X
OExMAN only if APuGo is turned OFF.
The following Table is only displayed when an optional Relay Board is installed
RC 0.1
RC 0.2
RC 0.3
RC 0.4
CLOSED
OPEN
ERROR
GONG
Only (1) PCB Terminal per Switch Activation is allowed. For example (2) activations (during closing and
opening) must be wired to (2) different PCB Terminals.
Note: The Configurator Menu will only display the following Elements/Values when the Relay PCB
Board is intalled.
Note: NABCO does not install more than (1) Relay PCB Board.
CLOSED Relay switches when the Door Panel is fully closed.
OPENING Relay switches when the Door Panel is opening.
OPEN Relay switches when the Door Panel is fully open.
CLOSING Relay switches when the Door Panel is closing.
ERROR Relay switches if the GT20 Control detects an Error(s).
PSAUTO Relay switches when the Program Selector is in Mode: AUTOMATIC
PSNIGHT Relay switches when the Program Selector is in Mode: NIGHT
PSEXIT Relay switches when the Program Selector is in Mode: EXIT
PSOPEN Relay switches when the Program Selector is in Mode: OPEN
PSMANU Relay switches when the Program Selector is in Mode: MANUAL
GONG Relay switches
momentarily
during the time the GT20 Control recieves a signal from:
Terminal 12 and Terminal 13 (Opening Command Inside).
LOCKED Relay switches during the time the Door Panel is LOCKED with an electric lock.
Table 12
Double Door Menu: Simultaneous Pairs and Astragal Pairs
Element Default Value Description
DubleD OFF MastrA
SlaveA
Determines closing sequence in case of Simultaneous Pair with Astragal.
AoSeq 0 0...110
X
X
Delay angle for opening sequence for Slave Door.
X
X
Only visible on Slave Control when DubleD is not OFF
AcSeq 0 0...110
X X
Delay angle for closing sequence for Master Door.
X X
Only visible on Master Control when DubleD is not OFF
TcSeq 1.5 0...3.0
X X
Time delay for closing sequence for Master Door.
X X
Only visible on Master Control when DubleD is not OFF
InterL OFF OFF
Side A
Side B
Two individual door Panels that are connected by CAM Bus. One Door Panel cannot open if
the other door is open. Also known as AirLock or Mantrap.
ILAuto Active Active
Inactive
X
X
Airlock functionality works in Automatic mode.
X
X
Only visible if InterL is not OFF