18
Important:
Table of maximum material removal.
On the scale (position D, Fig. 5.3.2.), it is FORBIDDEN to set a value lower than that
indicated in the right-hand column of the table. Otherwise, the machine may become
overloaded.
Note: The data is valid only for strength of steel to 45 kg/mm
²
.
Fig.5.3.1.1
It is forbidden to set value C lower than
indicated in the table – the machine may
become overloaded.
Material thickness up to 10 mm = no limit when
setting C.
Set as necessary.
All of bevels where is the width of bevel
(hypotenuse - position P Fig.5.3.1.0) bigger
than 10mm, is necessary to make in two steps.
For first step, set value C = C+1/2 A
